Mango and Passion Fruit Jam from Frozen Fruit: pH, Acidity and the Pectin Set

TB

Tbes Editorial Team

16 Nov, 2026

In short: Frozen mango and passion fruit start on opposite sides of the pH window that high methoxyl pectin needs. Ripe mango pulp measured pH 4.2 to 5.7 across nine cultivars. Yellow passion fruit pulp measured pH 2.40 to 2.98 across 26 genotypes. High methoxyl pectin sets at pH 2.8 to 3.5 with soluble solids above 60%. A jam built on either fruit alone needs pH correction. A blend does part of that work for you.

This note is for R&D and QA teams at jam, preserve and fruit spread makers in Poland, Czechia, Slovakia, Hungary, Romania and Bulgaria who are adding tropical lines. It covers the starting numbers, the recipe logic and what to write into the raw material specification.

What does pectin need to set?

Most firm jams use high methoxyl (HM) pectin. A 2025 study in RSC Advances describes commercial citrus HM pectin with a degree of esterification above 50% as needing soluble solids above 60% and a pH of 2.8 to 3.5 to form a gel (Tran et al., 2025). That is why jam lines control two numbers at the end of the boil: refractometer Brix and pH. The fruit decides how far each number starts from its target.

Where do mango and passion fruit start?

Published values for the two fruits and the pectin target, side by side:

  • Ripe mango pulp, nine cultivars: pH 4.2 to 5.7; soluble solids 15.7 to 20.0 °Bx; titratable acidity 0.05 to 0.22%; Brix-to-acid ratio 74 to 382 (Rodríguez Pleguezuelo et al.).
  • Yellow passion fruit pulp, 26 genotypes: pH 2.40 to 2.98; soluble solids 7.75 to 13.25 °Bx; titratable acidity 3.6 to 4.5% as citric acid; Brix-to-acid ratio 2.45 to 3.31; pulp yield 24 to 54% of fruit weight (Dantas et al., 2021).
  • HM pectin target: pH 2.8 to 3.5; soluble solids above 60% (Tran et al., 2025).

These are research values from orchards in Spain and Brazil. They show the range a formulator should expect. They are not a TbesAgri specification, so ask for lot results on the certificate of analysis.

What does that mean for a mango jam?

Mango brings sugar and body but little acid. At pH 4.2 or higher, the pulp sits well above the pectin window, so a mango jam needs added acid, usually citric acid, to set. The higher the mango share, the larger the acid dose. On the other side, mango at 16 to 20 °Bx gives the boil a head start toward the 60% soluble solids target, which shortens cooking time compared with a low-Brix fruit.

Set the pH target first, then the acid dose. Measure the pH of thawed pulp for each lot, then titrate a small sample to the target. Lots from early and late in the harvest can need different doses.

And for a passion fruit jam?

Passion fruit is the opposite case. Its pulp sits at or just below the lower edge of the pectin window, with acidity near 4% as citric acid. When passion fruit is the main fruit, the batch pH can fall under 2.8 and the set becomes harder to control. Formulators handle this by using passion fruit at a lower share, by raising pH with a buffer salt their recipe allows, or by pairing it with a low-acid fruit. Low Brix in the pulp also means more sugar and more boiling to reach the soluble solids target.

Why do mango and passion fruit work as a pair?

Each fruit corrects the other. Mango supplies sugar solids in a low-acid fruit base. Passion fruit supplies acid and a strong aroma at a small dose. A worked example on acidity, using mid-range study values:

  1. 70 parts mango at 0.15% acidity contribute 0.105 parts of acid.
  2. 30 parts passion fruit at 4.0% acidity contribute 1.2 parts of acid.
  3. The 70:30 fruit base carries about 1.3% acidity as citric, close to nine times the mango alone.

Acidity adds up this way. pH does not, because fruit acids buffer each other. Treat the calculation as a first estimate and confirm the pH of the blend in a kettle trial. For fruit share rules under the EU jam directive, see the guide for jam and purée makers.

What should the raw material specification state?

  • Format. IQF mango cubes or chunks with a size range; passion fruit pulp with seeds, or seedless with the sieve size in mm.
  • Soluble solids. °Bx at 20 °C on thawed fruit, with the sample preparation named.
  • pH. Target and range at 20 °C. For a jam line this matters as much as Brix.
  • Titratable acidity. Grams of citric acid per 100 g of pulp, with the method.
  • Colour and aroma. Against a reference sample agreed before the first order.
  • Microbiology and residues. Limits for total plate count, yeast, mould, E. coli and Salmonella, and a residue report against Regulation (EC) No 396/2005.
  • Pack and storage. Carton weight, liner, pallet pattern and storage at −18 °C.

The IQF mango specification guide and the passion fruit preparation guide cover each fruit in more detail.

How should QA check the first lot?

  1. Thaw under your standard procedure. Measure °Bx, pH and titratable acidity in triplicate.
  2. Compare the results with the certificate of analysis.
  3. Cook a small kettle batch at the target fruit share. Record final Brix and pH.
  4. Check the set after 24 hours and adjust acid or pectin before scale-up.

Fruit chemistry moves through the season, so plan lots against the Vietnam harvest calendar and repeat the check when the harvest window changes.

Frequently asked questions

Why is passion fruit jam harder to set than mango jam?

Passion fruit pulp can sit below pH 2.8, the lower edge of the window for high methoxyl pectin, and its low Brix needs more sugar and boiling. Mango has the opposite problem: too little acid. Both are fixed in the recipe, and a blend narrows the gap.

Which numbers should a jam maker ask the supplier for?

°Bx at 20 °C, pH and titratable acidity as citric acid, all measured on thawed fruit, per lot. Add colour, aroma, microbiology and a residue report.

Do the study values apply to fruit from Vietnam?

They show the typical range for each fruit, measured in Spain and Brazil. Cultivar, ripeness and harvest month change the numbers, so build the recipe on lot data from your supplier.

Sources

  • Tran, T.N.M., Dieu, N.T.T., Nguyen, T.H.N., Le, V.D. et al. (2025). Waste robusta coffee husk pectin: ultrasound-assisted extraction and applications in roselle flower marmalade and fruit coating. RSC Advances, 15(44), 36625-36641. https://doi.org/10.1039/d5ra05086c
  • Dantas, A.M.T., Costa, A.P., Peixoto, J.R., Junqueira, N.T.V. and Carmona, R. (2021). Physicochemical characteristics in passion fruit as affected by harvest times. Embrapa repository. alice.cnptia.embrapa.br
  • Rodríguez Pleguezuelo, C.R., Durán Zuazo, V.H., Muriel Fernández, J.L. and Franco Tarifa, D. Physico-chemical quality parameters of mango (Mangifera indica L.) fruits grown in a Mediterranean subtropical climate (SE Spain). researchgate.net

Planning a tropical jam line? Request the specification and a sample for frozen mango or frozen passion fruit.

Request a specification and quotation

Send the product, cut or size, packing, quantity and destination port. Our export team replies with a specification and price.

Get In Touch

Our team is available to answer your questions. Please fill out the form and we'll be in touch shortly.

*Please share the details of your request, and if applicable, the specific product you're interested in.